PDA

View Full Version : Supercharging the Split-Port V6, roots style Work in Progress



MasterX
05-02-12, 09:46 AM
My car is a 2004 Dark Shadow Gray Convertible with 3.9L V6.

The blower is an M90, you may say, ha ha not possible without a singleport swap. think again!

First the car in question: Click to Enlarge

http://whoismasterx.com/mycar/carthumbs/IMAG0485.jpg (http://whoismasterx.com/mycar/IMAG0485.jpg)



http://whoismasterx.com/mycar/carthumbs/IMAG0487.jpg (http://whoismasterx.com/mycar/IMAG0487.jpg)

http://whoismasterx.com/mycar/carthumbs/IMAG0488.jpg (http://whoismasterx.com/mycar/IMAG0488.jpg)

I rebuilt this car from crash condition, previous owner rear-ended a truck.
Custom 4" Cold Air Intake
2004 GT Hood with Scoop - Custom Paint
SCT X3 Handheld Flash Tuner
Screaming Demon Ignition Coil Pack
SPEC-D Angel Eyes Halo LED Headlights
OBDII Bluetooth Diagnostics Chip - Engine Readouts on Laptop/Tablet

Now for the Fun Part!

Adapter Plates are being milled from wood only for test and fitment purposes, finalized design will be billet aluminum.

Making of the M90 Split Port Adapter Plate Video

http://www.youtube.com/watch?v=3NmAvM4q7Ho

Making of the Third Revision of the Adapter plate video

http://www.youtube.com/watch?v=2WNa_sa8ors

BurnTire
05-02-12, 11:56 AM
Nice project you got going. :thmbsup:

MasterX
05-02-12, 12:30 PM
Nice project you got going. :thmbsup:

It is gonna be a chimera setup with a GM blower. M90 3800 blower used in buick pontiac and chevys.

was hoping to use the supercoup thunderbird blower but it would require the plate to extend 2 inches forward of the lower manifold and relocation of several things in that area.