PDA

View Full Version : Ratt Running 9's again.



BurnTire
02-18-07, 09:04 PM
http://www.youtube.com/watch?v=http://www.youtube.com/watch?v=xV9i6VxQXg8

Ratt Fink
02-22-07, 11:14 PM
Oooo, dat was scary on the big end !

BurnTire
02-22-07, 11:48 PM
Oooo, dat was scary on the big end !

Saw a little sway on the top end. What happened?

Ratt Fink
02-26-07, 08:21 PM
Saw a little sway on the top end. What happened?

The big end was re-surfaced, and it is still not packed down hard, the best I can tell. Seems every time I get past the 1/8th mile, she starts walking around. Maybe it just needs a nice "groove" worn in ?

Gene
02-26-07, 10:06 PM
amazing james! In a 6 speed to boot! Do you have a license for 9's?

Ratt Fink
02-27-07, 11:14 PM
amazing james! In a 6 speed to boot! Do you have a license for 9's?

Thanks ! I don't have a 9 sec license, so I only get one 9 sec pass before getting sent to tech. Also the reason I don't add more power or take off any more weight (~3530 lbs racing weight).

BurnTire
02-27-07, 11:25 PM
Is that a bone stock T56?

Ratt Fink
02-28-07, 09:16 PM
Is that a bone stock T56?

No, it has a Liberty 26 spline input shaft... uses Royal Purple Dexron III ATF. Oh, and a piston shift knob, of course !!

Gene
02-28-07, 10:10 PM
No, it has a Liberty 26 spline input shaft... uses Royal Purple Dexron III ATF. Oh, and a piston shift knob, of course !!

Thats pretty much arizona stock sans the piston knob LOL!

Ratt Fink
03-01-07, 06:55 PM
Thats pretty much arizona stock sans the piston knob LOL!

Yep, it is ! Actually has not had the 3-4 synchronizer struts changed or anything else. And, Ratt Fink did the input shaft install, and shimming, all by hisself ! :veryhappy:

BurnTire
03-01-07, 07:49 PM
Yep, it is ! Actually has not had the 3-4 synchronizer struts changed or anything else. And, Ratt Fink did the input shaft install, and shimming, all by hisself ! :veryhappy:

Did you need to re shim or did the stock shim work?

Ratt Fink
03-04-07, 02:55 PM
Did you need to re shim or did the stock shim work?

The stock shim would have been too thick, actually, on my trans. I believe it required one about .003" thinner.