PDA

View Full Version : Need help with axle replacement



99WhiteGT
02-23-09, 10:06 AM
Hey guys i need some help replacing my driver side rear axle. It snapped. When it snapped it pulled of the rotor so i already got the brakes off. So i know i need to

Pull the diff cover
Take out the 8mm bolt
Take off the c-clip
Slide out the axle

But i need a new seal and bearing, what my question is; is that is there just a bearing and seal, or is there a cuppling (spelling?) as well that goes in after? idk because when the axle came off all that was left in the tube was a bearing and seal but i thought there was a cuppling that went in after you put those in. any help would be appreciated Thanks, and if anyone is willing to help ill pay for pizza and beer. Im looking at doing it this weekend if then next weekend for sure.

BurnTire
02-24-09, 10:59 AM
I believe the bearing an seal just press into the axle end. It has been a long time since I did one.

99WhiteGT
02-24-09, 12:01 PM
Ok thanks, hopefully it will be up and running soon, so i can come put some numbers down on the track w u guys, just got a bunch of stuff done to the engine so lookin forward to that.