Forum: 2005-2010 Mustang

Well Hurst has FINALLY released the Billet Competition Short Throw Shifter and we have them here in stock. This is not to be confused with the...

I am pulling the valve covers for powder coating and obviously do not want any leaks after install. I can not find who carrys new ones. I thought I...

I'm thinking of adding 20 inch wheels to my 2009 V6 mustang. Have a few concerns that maybe someone might know the answer. Does adding the wheels...

I was surprised, again??? At two years I had a bad battery, a cell went bad. Got a new one and was supprised at the increased performance??? It...

Just started having problems tonight. Car will overheat unless it stays moving (possible indication of bad fans), and there is a wire-burning smell...

Well I've just about had it with this thing. After installing the clutch two months ago the pedal hit the floor on friday... Pulled the trans down to...

Which cars have the switch in the dash to turn on/off the TCS, or traction control? I've been Mustang shopping, and found some don't. All 05 - 06's...

I was test driving a '05 GT, doing about 35MPH, then I stomped on it. There was a BIG delay, no rev, no kickdown, felt like bad turbo lag - then it...

I just got the Shelby back from PSR. Before any mods they ran a baseline run and got 479.10Hp and 473.00Tq at the wheels. After the install of...

If this is the wrong forum, sorry. I have two questions and I will be as clear as possible. I'm having a couple issues with my A/C, first one...

So I received a pair of Prothane motor mounts (red) for Christmas. I am getting ready to attack the job soon and have been reading several threads...

not really sure how it blew but my number 2 cylinder is gone. fazm made it so that it will drive right now but sooner or later it will completely...

ok finally saved enough to get cams most likely gettin stage 1 cuz dont want to change gears so should i stick to my idea with stage 1 or shuld i...

Anyone know a good and hopefully inexpensive oversized rotor set up that uses the stock calipers? The Baer EradiSpeed system is pricey.

gears for my rear.. option 1 3.73 option 2 4.10 lookin for a little more aggressive acceleration and "attitude" then stock. Nothing...

I have a 2008 GT. It is fire torch red with white stripes tip to tail and along the sides. It looks very nice, now I just need it to be more...

Well I have only been lurking around for about 8 months since I bought my 05 Mustang GT. Sadly, I had to get rid of it today for an SUV for the...

Anybody have cams installed on their 3v in Arizona? Or had the heads or intakes ported? Anybody have some ballpark prices out here, I know every...

While at the track teaching a lady BULLITT owner how to drag race, I met another BULLITT owner with a Whipple and discussed his problems he was...