+ Post New Thread
Page 1 of 7 1 2 3 ... LastLast
Threads 1 to 20 of 124

Forum: 1979-1993 Mustang

  1. Arrow 88 convertible window alignment - who is good at it?

    I need to get all of my windows aligned properly in my '88 GT vert. Does anyone know a person or a shop who is good at it and can do it right?

    Started by 1tuff68, 07-16-10 01:18 PM
    alignment, window
    • Replies: 0
    • Views: 108
    07-16-10 01:18 PM Go to last post
  2. Question Starter Solenoid Issue...

    I went to start the stang today and the starter kept cranking the engine and would not stop without disconnecting the battery cable... I tried taking...

    Started by 89GT, 06-04-10 03:05 AM
    • Replies: 8
    • Views: 726
    07-08-10 12:40 AM Go to last post
  3. Question Check engine light location

    Was wondering if someone could tell me the location of the CEL on an 89 GT. I think the bulb is blown. I tried locating it with a flashlight with no...

    Started by 89GT, 06-19-10 09:42 AM
    • Replies: 2
    • Views: 537
    06-25-10 11:02 PM Go to last post
  4. New problems.... AHHH!

    Ok just scanned the EEC-IV for codes. I have alot, most pertaining to a lean condition. Here they are, and they are all stored ones no active....

    Started by 89GT, 06-11-10 01:21 PM
    • Replies: 2
    • Views: 464
    06-16-10 11:35 AM Go to last post
  5. Angry Idle Issue 89 GT

    I picked my 89gt up sunday and found out that the TPS is unplugged. Let me start off that it had a surging idle it would go from almost dying to...

    Started by 89GT, 05-12-10 02:02 AM
    2 Pages
    1 2
    • Replies: 10
    • Views: 1,224
    06-11-10 01:54 AM Go to last post
  6. Bright Calypso Green Clearcoat Metallic info wanted

    I love this color and have recently "rediscovered" it. Searching the web, it seems it was only offered 91-93. Correct? And in low numbers each...

    Started by FalconGTHO, 05-18-10 03:08 AM
    • Replies: 7
    • Views: 807
    05-21-10 02:33 AM Go to last post
  7. Question Headlight Relay Harness

    I just built a home-made headlight relay harness for my '88 fox. I couldn't find any pre-made commercial harnesses that I could buy. I built it such...

    Started by 1tuff68, 04-04-10 06:08 PM
    • Replies: 0
    • Views: 501
    04-04-10 06:08 PM Go to last post
  8. 1993 Mustang Cobra

    I'm curious what the opinions are regarding the 93 Cobra. What would you pay for a quality one and do you think there is any collectible value with...

    Started by JoeT, 03-31-10 01:21 PM
    • Replies: 2
    • Views: 435
    03-31-10 03:08 PM Go to last post
  9. ECM options

    I am running '87 5.0 H.O. (speed density) injection in my '73 Bronco on a 289 small block. I have heard that if I swith from a manual trans module...

    Started by Lil Blu, 02-25-10 07:04 PM
    • Replies: 5
    • Views: 744
    03-01-10 11:16 PM Go to last post
  10. afr 165 , coolant passages

    i have a set of afr heads and they are a little older . they have the coolant passage so they require the cometic c5911-040. has anyone ever used...

    Started by desert fox, 01-19-10 10:06 PM
    • Replies: 0
    • Views: 832
    01-19-10 10:06 PM Go to last post
  11. My Notch Build Tons Of Pics

    I just wanted to share my fox build with you guys although it has already been in the works. I plan to update the car a bit and show progress on the...

    Started by BUSTED, 01-06-10 12:37 AM
    3 Pages
    1 2 3
    • Replies: 21
    • Views: 1,816
    01-14-10 07:43 AM Go to last post
  12. Convertible Window Molding?

    Can the molding in this picture that is covered with duct tape be replaced? I have been looking on Latemodel restoration and I can't find it at all....

    Started by cdhstang, 01-06-10 10:01 PM
    • Replies: 2
    • Views: 279
    01-07-10 05:01 AM Go to last post
  13. Cool Starter solenoid issue

    I have a 84 gt350 5.0 Carb. If anyone can help it would be greatly appreciated. I have went through about 6 starter solenoids. I have replaced...

    Started by brokedown84, 11-24-09 04:34 PM
    • Replies: 4
    • Views: 586
    01-03-10 04:21 PM Go to last post
  14. 5.0 rebuild

    Anyone know of a reputable machine shop for 5.0 motors in the Dallas/Houston Tx. area? My car has been sitting for a couple years, it now smokes and...

    Started by blklx, 12-14-09 05:53 PM
    • Replies: 0
    • Views: 459
    12-14-09 05:53 PM Go to last post
  15. Burning oil

    Hey guys, I have a small issue. Burning 1 quart of high mielage oil every 100 miles! The car is in the shop today. They pulled the intake and...

    Started by xsenerg, 12-08-09 04:06 PM
    • Replies: 2
    • Views: 436
    12-14-09 12:20 PM Go to last post
  16. 88 ignition switch

    Anyone with information on how to change out an ignition switch on a 88 mustang?

    Started by blklx, 12-05-09 08:08 PM
    • Replies: 3
    • Views: 416
    12-11-09 07:50 AM Go to last post
  17. Wrenching?

    This is short notice I know but Friday I'll be stabbing the driveline in my Fox and could use a second set of eyes. If anyone's interested shoot me a...

    Started by White90GT, 12-09-09 10:41 AM
    • Replies: 0
    • Views: 455
    12-09-09 10:41 AM Go to last post
  18. a/c trouble

    ok i bought a 92 convertible mustang from my neighbor we both worked on it togheter and all but b4 he sold it to me his lil bro forgot to clip on the...

    Started by Zennky04, 11-17-09 02:26 PM
    • Replies: 4
    • Views: 469
    11-22-09 11:15 PM Go to last post
  19. Clutch cable routing

    I'm swapping the A4LD for a T5 in my 88LX with the 2.3. Since i've never actauuly seen how the clutch cable routes I need to ask. I bought all the...

    Started by QuarterHorse, 09-25-09 05:51 PM
    • Replies: 2
    • Views: 889
    09-30-09 11:09 AM Go to last post
  20. Angry Overheating Problem 331 stroker

    I have a '90 LX with a motor that has less than a 1000 miles. It has a Systemax top end with aluminum heads. I'm on my second thermostat. The motor...

    Started by rgerdes, 09-03-09 01:35 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 1,738
    09-05-09 07:13 AM Go to last post

+ Post New Thread
Page 1 of 7 1 2 3 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts