Results 1 to 10 of 10

Thread: Hp Turbo kit

Threaded View

  1. #1
    Senior Member
    Join Date
    Jan 2009
    Location
    Phoenix
    Posts
    948

    Hp Turbo kit

    These pics are for everyone planning on building a twin turbo car. One of our customers had bought a kit from a turbo company in New Mexico, because everyone on this site said that they have the best kit. You might want to think twice before spending your money on this junk! This turbo kit was a head ach from day one.
    First off we waited forever for the kit; the next hang up was they sent two headers for the same side along with the same side down pipe. It’s a good thing that we live in phoenix, because we had to go to Jet hot to pick up the correct parts personally. After we had the complete kit we quickly found out that the fitment was pure crap! For example the pipe from the header was so wrong that it bound the whole left side turbo causing the exhaust pipe hit the k-member. They also had fabricated a section of exhaust out of flex pipe that looked just like the flex tube at Pep Boys. After careful consideration we had decided to cut off the flex tube due to excessive leaks at that particular joint... the H-pipe was also a Gem all on its own, according to there instructions we would have to cut the pre existing cat back and weld the H-pipe in it’s place. So with that in mind I wondered what would happen if a clutch was ever to be done on this car? Would we have to cut the pipe off again? The answer was to either having the customer investing in a welder and a lift, or just make a new section of pipe so that the customer would be able to do his own clutch if he wanted... We also had noticed that the left tire would clearly hit the exhaust piping when making a right hand turn. After the kit was finally in and running we quickly had a problem, the car would not idle due to the inner cooler pipe being smashed with a hammer (Why didn’t they just buy oval pipe?) To make an oval to squeeze between the bumper crumple zone and the header panel not to mention that this would never seal correctly due to the crudeness of the ovaling, then trying to bolt to a round pipe. Needless to say we had to add about 1.5 inches to that pipe (due to poor fitment causing the exhaust to hit the k member that we have already mentioned). After we finally had the car running again we noticed a whistling noise from under the hood. Yep you guessed it another problem. The turbo company in question also has hit the tube that went from the inner cooler to the Throttle body with a hammer to make to oval pipe for the acufab (please see the pics and notice all the dents caused by the hammer in question) and the hit it so much that it was now concaved (reward for this hammer because this tech clearly should not possess a tool with this much power) and not able to seal (but they had it coated that must be a A+ for them!). We have had so many problems with this kit that we now have elected to trash the entire kit all together and make all our own Pipes for this unit. I am not talking shit and I took pics to back up my statements. I’m sure that company does nice work when it is at there shop as for the mail order kits…. Well lets just say I would rather have a large wing and a body kit from a ricer magazine than to mess with another one of there kits.





    yes this is all from shaggys car



    this is my verndor review
    Last edited by BurnTire; 09-20-06 at 11:22 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •