Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: UPR Pro Street Double Adjustable UCA Issue

  1. #11
    Senior Member SloSVO's Avatar
    Join Date
    Oct 2008
    Location
    Buckeye, Az
    Posts
    586
    i don't see it being too hard to just remove it and flip it around.. if its backwards

  2. #12
    Junior Member
    Join Date
    Oct 2009
    Location
    Kingman, AZ
    Posts
    10
    Did not have lift, so rather difficult getting into that area from underneath.

  3. #13
    Senior Member BUSTED's Avatar
    Join Date
    May 2008
    Location
    Arizona
    Posts
    272
    I had a minute I thought I would go to UPR's website. Look at the way it is in the picture. There is no brace on the other side of the arm and it is also flipped over in UPR's relocation bracket. Again I'm about 100% sure this is an install mistake.

    http://www.uprproducts.com/mustang-c...-mount-05.html

    But on a side note, I'm sure it will work fine with the ding your tech helped put in your new part.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •